VersaTools® MDA EQ Series • Quick Start Guide
Quick Start Guide — MDA EQ Series
To install and set up an MDA EQ Series mini distribution
amplifier, follow these steps:
Step 1
Turn all of the equipment off and disconnect it from the power
source.
Step 2
Mount the MDA EQ on a projector, under a desktop, or on a rack
shelf, as illustrated below. (The illustration shows a VersaTools®
rack shelf; you can also use the standard or 6-inch deep Universal
19-inch rack shelves. See Optional Accessories in appendix A.)
Step 3
Wire the MDA EQ power cord and connect it. To wire the power
cord, follow these steps, and refer to the illustration on the next page.
a. Cut the DC output cord to the length needed.
b. Strip the jacket to expose 0.2 inches (5 mm) of the
conductors.
c. Slide the leads into the supplied captive screw plug and
lock them, using an Extron Tweeker (small screwdriver).
Ceiling
Projector
Projector
Mounting
Bracket
Mounting
Bolt
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
QS-1
