VersaTools
®
MDA EQ Series • Installation and OperationVersaTools
®
MDA EQ Series • Installation and Operation
Installation and Operation
2-3
Mounting the MDA EQ Series
The MDA EQ mini distribution amplifiers can be set on a table;
mounted on a rack shelf; attached to a projector; or mounted
under a desk, podium, or tabletop.
The following kits are available for mounting the MDA EQ:
• RSB 123 1U, 3.5" deep basic VersaTools rack shelf (part
#60-604-20)
• RSF 123 1U, 3.5" deep VersaTools rack shelf kit (part
#60-190-20)
• RSB 126 1U, 6" deep basic rack shelf (part #60-604-10)
• RSU 126 1U, 6" deep universal rack shelf kit (part
#60-190-10)
• RSB 129 1U, 9.5" deep basic rack shelf (part #60-604-01)
• RSU 129 1U, 9.5" deep universal rack shelf kit (part
#60-190-01)
• MBU 123 mini under-desk mounting bracket kit (part
#70-212-01)
• VersaTools projector mounting kits: PMK 100 (part
#70-367-01), PMK 300 (part #70-374-01), or PMK 350 (part
#70-563-02 or 70-563-03).
Tabletop use
Four self-adhesive rubber feet are included with the MDA EQ.
For tabletop use, attach one foot at each corner of the bottom
side of the unit and place the unit in the desired location.
Rack mounting
For optional rack mounting, mount the MDA EQ on one of the
rack shelves or projector mounting brackets listed above. On
the standard 9.5" deep rack shelves, the unit can be mounted in
one of four locations to the rear of the rack or in one of four
locations to the front of the rack.
N Only products in the VersaTools and IP Link lines can be
mounted on a VersaTools shelf. Any 1U rack-mountable
Extron product can be mounted on the standard shelf.
1. If rubber feet are installed on the bottom of the MDA,
remove them.
2-2
2. Mount the MDA EQ on the rack shelf, using two
4-40 x 3/16" screws in opposite (diagonal) corners to
secure the unit to the shelf.
3. Install blank panel(s) or other unit(s) on the rack shelf.
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Mounting MDAs on a VersaTools rack shelf
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
1/4 Rack Width Front False
Faceplate
1/2 Rack Width Front False
Faceplate
Mounting an MDA EQ on a standard rack shelf
