2-3
Printing with EPSON Stylus RIP for Macintosh
If you connected the printer via a network interface card
and use AppleTalk zones, select the printer’s zone and then
select the printer name. Or use the
Scan
button to locate
the printer on your network.
Click
OK
once you select the printer and port.
Note:
If you change your printer connection later, you must
reconfigure EPSON Stylus RIP for your new port. To do so,
start EPSON Stylus RIP and select
Printer Connection
from
the PostScript menu. Follow the on-screen instructions.
6. If the printer has not been previously licensed for
PostScript, or this is the first time you’ve run the Stylus RIP
Server, a dialog box prompts you for your EPSON Stylus
RIP license key. (The license is printed on your CD-ROM
sleeve.) Type it exactly as shown and click
OK
.
The Stylus RIP Server
software searches for the
printer, checks printer
settings and licenses, and
then displays the Stylus
RIP server window. Leave
the window open.
If you’re using EPSON Stylus RIP on a standalone Macintosh,
continue with “Setting Up Your PostScript Printer” on
page 2-5. If you’re using EPSON Stylus RIP on a network, or if
you want to set preferences, follow the steps in the next section
to configure the software for your system.
Nflight.bk Page 3 Friday, September 1, 2000 8:32 AM
