A SERVICE OF

logo

Using Short Tear-Off
Adjusting the tear-off position
If the paper’s perforation does not line up with the tear-off edge,
you can adjust the tear-off position using the micro-adjustment
feature.
1.
Make sure the short tear-off feature is turned on so the printer
feeds paper to the tear-off position after printing the
document. The ON LINE light should begin blinking, meaning
you can now use the micro-adjustment feature to make fine
adjustments to the tear-off position.
CAUTION: You can only use the micro-adjustment
feature while the ON LINE light is blinking.
Using the Printer
3-17