A SERVICE OF

logo

Open as PDF
next previous
Figure 3-5. Printer parts used with pin-feed paper
4.
Set the paper support skids evenly from the approximate center of
the paper width (as shown in Figure 3-6). This helps the paper feed
smoothly.
Note: If you are using narrow or standard width paper, you must
insert it at the far left of the platen (just as you did with single-
sheet paper).
5. Make sure the platen release lever is closed (back).
Inserting pin-feed paper
Now that you have prepared the printer, you can load the pin-feed
paper by following these steps:
1. Make sure you have a clean top edge. Insert the pin-feed paper into
the paper guide slit at the rear of the platen as shown in Figure 3-6.
(If the sheet guide unit is installed, slide the paper underneath it.)
37