8
Part Names and Functions
Rear
Base
• [SCART] input port s page 12
Connects to the SCART ports of
other video equipment using the
D4 SCART adaptor that is packed
with the projector.
• [Trigger out] port
When the projector
power is turned on, a
12 V DC signal is output from
this port. When the projector's
power is turned off or a
problem with operation occurs,
the output becomes 0 V to
send the projector's power
ON/OFF status to an external
device.
• [Video] input port s page 12
Connects to general video ports of
other video equipment.
• [HDMI ] input port s page 12
Connects to video equipment or a
computer that is HDMI-compatible.
• [S-Video] input port s page 12
Inputs an S-Video
signal to the
projector from other video equipment.
• [RS-232C] port
Connects the projector to a computer
using an RS-232C cable. This port is
for control use and should not be used
by the customer.
• Power inlet s page 14
Connects the power cable.
• Main power switch
s page 14
• Security lock
s page 54
• Remote control
light-receiving
area
s page 13
Receives signals
from the remote
control.
• [InputB] port s page 12
Connects to the RGB port
of a computer.
• [InputA] port s page 12
Connects to the component video
(YCbCr or YPbPr ) ports
of other video equipment.
• Suspension bracket fixing points (4 points) s page 47
Install the optional ceiling mount here when suspending the projector from a ceiling.
• Air filter (air intake vent)
s page 42, 44
Prevents dust and other foreign particles
from being drawn into the projector.
It should be cleaned periodically.
• Lamp cover s page 45
Open this cover when replacing the lamp
inside.
