Epson R2400 Manual

next previous

Epson Stylus Photo R2400

16 - Epson Stylus Photo R2400 2/05

3. Clean the exterior of the printer with a soft, damp cloth.

Keep the paper support and printer cover closed as you

clean the printer.

4. If you need to clean ink out of the inside of the printer, use

a soft cloth to clean only the black plastic area shown below:

WARNING: Don’t touch the gears or rollers inside the printer.

Caution: Never use a hard or abrasive brush, or benzine, alcohol, or

thinner for cleaning; they can damage the printer components and

case.

Don’t get water on the printer components and don’t spray or apply

lubricants or oils inside the printer.

Don’t use any cleaning sheets included with special paper; they

may jam inside the printer.

Transporting the Printer

If you move your printer some distance, you need to prepare it

for transportation in its original box or a similar one. Follow

these steps:

1. Turn on the printer.

2. Turn off the printer and unplug the power cord from the

electrical outlet. Then disconnect the printer cable from the

printer.

3. Open the printer cover and tape the ink cartridge holder to

the printer case using tape. Then close the printer cover.

Caution: Be sure to remove the tape after installing the printer in

its new location.

4. Remove any paper from the printer, then remove the roll

paper holder, if it is installed.

5. Close the output tray and the paper support.

6. Repack the printer and its attachments in the original box

using the protective materials that came with them.

7. Keep the printer level as you transport it.

8. After transporting the printer, remove all the tape.

9. Test your printer. If you notice a decline in print quality,

clean the print head (see page 13); if output is misaligned,

align the print head (see page 15).