1. Make sure the printer is turned on. If necessary, lift up the
printer cover so you can see the paper position.
2. Load either continuous or single-sheet paper. (Press the
Load/Eject
button to load continuous paper or a single sheet
from the optional cut-sheet feeder.)
3. Hold down the
Pause
button for about three seconds. The
Pause
light starts flashing and the printer enters the
micro-adjust mode.
4. Press the
LF/FF
[
D
] button to move the loading position down
on the page, or press the
Load/Eject
[
U
] button to move the
loading position up on the page.
Note:
q The printer has a minimum and a maximum loading position. If you
try to adjust the loading position beyond these limits, the printer
beeps and stops moving the paper.
q When the paper reaches the factory-set loading position, the printer
beeps and paper feeding pauses briefly. Use the factory setting as a
reference point when adjusting the loading position.
A41
L
Adonis Rev.E
A5 size Chapter 3
97/04/07 pass 0
3-28
Paper Handling
