To tear off and eject overlapping multi-part forms with
labels
Always tear off and eject overlapping multi-part forms with
labels by following the procedure below.
Note:
In
mode, the
Tear Off
button is disabled and the
Load/Eject
button only feeds forms forward.
1. At the back of your printer, tear off the last overlapping
multi-part form that has entered the printer.
2. Press the
LF/FF
button to eject the last overlapping multi-part
forms with labels forward.
3. To print on another type of paper, press the
Paper Select
button to select
and make sure the # message
appears on the control panel display.
c
Caution:
Do not leave overlapping multi-part forms with labels loaded
in the printer between print jobs; they tend to curl and may
come off their backing sheet and jam the printer when you
resume printing.
3
R
Maple Rev.D
A5 size Chapter 3
97/06/17 pass 0
Paper Handling
3-35
