74
9 Management
9.1 Administration
This page allows you to change the ECB350 password as well as
configure the device by remote access. By default, the username is
admin and the password is: admin. The password can contain 0 to
12 alphanumeric characters and is case sensitive.
Note: Remote Access is only applicable in AP Router and Client Router mode.
Change Password
Name Enter a new username for logging in to the New Name entry box.
Password Enter a new password for logging in to the Password entry box.
Confirm Password Re-enter the new password in the Confirm Password entry box for confirmation.
Save/Apply / Cancel Click Save/Apply to apply the changes or Cancel to return previous settings.
Remote Access (only applicable in AP Router and Client Router mode)
Remote Management Enable or Disable remote management.
Remote Upgrade Specify whether the firmware of the ECB350 can be upgraded remotely.
Remote Management Port If remote management is enabled, enter the port number to be used for remote management.
Example: If you specify the port number to 8080, enter http://<IP address>:8080 to access the
ECB350.
