TM
Page 4
Reference manual Foundation Fieldbus Control module
DOC.RM.QC34.E Rev: A
October, 2006
A7 Hazardous areas
Improper installation in a hazardous area
can cause an explosion.
• Assembly, disassembly and maintenance
must be done outside potentially explo-
sive area’s
• For information about installation in a
hazardous area, refer to the appropriate
sections of the Installation Guide, as
shipped with the control module.
A8 Warning ; Moving parts
• Applying pressure to the actuator or
• Applying a control signal to the Control
module, may cause the actuator/valve
assembly to operate.
A9 Prevent moisture entering the
actuator
Condensation or moisture that enters the
actuator, the pneumatic module or the
control module can damage these compo-
nents and can result in failures. Therefore:
• Try not to mount the actuator with the
conduit openings or the air entries,
pointing upward.
• Ensure integrity of gaskets and o-rings.
• Install drip loops in conduit or cable.
• Seal all conduit openings whether used
or not.
A10 Warning ; Magnetic material
* Do not put the FieldQ in direct contact
with magnetic material. This can cause
damage or malfunction.
A11 Warning ; Temperature range
* Do not exceed the temperature limits of
the module as specified in this manual or
in the Installation Guide DOC.IG.QC34.1.
This can cause damage or malfunction.
