A SERVICE OF

logo

Open as PDF
next previous
Mobile Base Installation Guide
CHAPTER 1
Preparation
1-4
4 Remove the four bolts securing the hood to the dyno and prop up the hood.
5 Disconnect the wires to the key switch if present.
6 Remove the hood from the dyno and set aside.
7 Disconnect the battery.
Figure 1-2: Remove the Hood
REMOVING THE EDDY CURRENT BRAKE
1 Remove the following cables and wiring.
1a Remove the four screws securing the Breakout board and cover. Set the
cover and screws aside.
1b Disconnect the temperature sensor cable from the Breakout board. The
temperature sensor cable has five wires which connect to the wiring block
labeled TEMP.
Figure 1-3: Remove the Temperature Sensor Wires
• Green wire connects to G1 • White wire connects to W1
• Black wire connects to B1 • Red wire connects to R1
• Ground wire connects to S1
key switch
temp
Breakout board
and cover