A SERVICE OF

logo

- 23 -
Trouble Shooting
General Problems
Q: The OSD menu does not display a
on a channel
where a computer is connected and powered up.
What do I do?
A:
˙
DKVM-8E will updated “
“ every 2 seconds. Using
hot key to access the OSD menu again and it
should have re-detected all the active channels.
Q: When cascading the MASTER unit does not see the
slave unit(s).
A:
˙
Refer to the Installation section for information on
how to properly connect the daisy-chain cable.
˙
Make sure the daisy-chain cable that you are using
is right. Using any other cable will not guarantee
proper operation or video quality.
˙
Reset the all slave unit first and then reset master
unit to get the lost slave unit.
˙
Although a power supply is not necessary to make
the slave unit work, try adding a power supply.