DES-3550 Fast Ethernet Layer 2 Switch
To configure the Access Rule for Ethernet, open the Access Profile Table and click Modify for an Ethernet entry. This
will open the following window:
Figure 6- 59. Access Rule Table
To remove a previously created rule, select it and click the
button. To add a new Access Rule, click the Add button:
Figure 6- 60. Access Rule Configuration window (Ethernet).
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Access ID
Type in a unique identifier number for this access. This value can be set from 1 - 50.
91
