11
1. Add one drop of DeVilbiss DV1719-01 Air Tool Oil, high
speed spindle oil such as Unocal RX22, or 3-in1 oil
into the air inlet.
2. Attach a Quick Connect Fitting to the tool.
3. Connect the Tool to an air compressor using a 3/8" I.D.
hose. (The magazine must be empty of all fasten-
ers). Make sure the hose has a rated working pressure
exceeding 150 PSI and a Female Quick Coupler.
4. Regulate the air pressure to obtain 65 PSI at the tool.
Check the operation of the Contact trip safety mecha-
nism following the instructions in this manual.
5. Load fasteners into your tool following the instruction in
this manual.
6. Reconnect the air hose to the tool.
7. Test for proper fastener penetration by driving fasteners
into a sample piece of material. If the fasteners do not
achieve the desired penetration, adjust the air pressure
to a lower or higher setting until the desired penetration
is achieved. Do not exceed 100 psi at the tool.
OPERATING THE TOOL
Figure 5
Disconnect tool from air supply before adjusting,
clearing jams, servicing, relocating and during
non-operation.
CLEARING A JAM FROM THE TOOL
FASTENER JAM INSIDE MAGAZINE:
1. Disconnect tool from air hose.
2. Pull up on #56 Stopper. Pull back on #50 Reel Plate
to open magazine. (Items #50 and #56 on page 13)
3. Remove jammed fastener from magazine.
4. Push Reel Plate forward until catch under stopper.
1. Disconnect tool from air hose.
2. Pull up on Stopper #56. Pull back on Reel Plate #50
to open magazine. (Items #50 and #56 on page 13)
3. Pull up on Stopper #56. Pull back on Reel Plate #50
to open magazine.
4. Remove fasteners in magazine.
5. Remove 2 screws from nose door.
6. Remove nose door.
7. Grab jammed fastener with pilers and remove.
(See Figure 5)
8. Reposition nose door and secure with 2
screws.
9. Reload fasteners.
10. Push Reel Plate forward until catches under stopper.
FASTENER JAMMED IN FASTENER DISCHARGE AREA:
