Press the Program SET button. The Program SET button and START T
illuminate. Press the HRS and MIN buttons to set the S
LED illuminates. Press the HRS
and MIN buttons to set the E
LED illuminates. Press the HRS
ET CLOCK LED illuminates. Press the HRS ET CLOCK
and MIN buttons to set the current clock time into the unit.
NOTE: The AM/PM LED will change with the HRS button.
Programming the Temperature SET POINT
button until the current S
begins to fl ash on and off. Select a new desired S
▼
▲
Programming the Fan Speed
button until one of the Fan Speed button LEDs (High/Low)
begin to fl ash. This is the current programmed Fan Speed. To change the pro-
grammed Fan Speed, simply press the other Fan Speed button.
Exiting the Program SET Function
After changing any of the above settings, continue pressing the Program SET
button until the Program SET button LED turns off. The unit will then return to the
Activating/Deactivating a Preset Program
Press the Program RUN button to activate/deactivate a preset program. The Program
LED will illuminate when activated.
• The unit will return to the previous mode if a program is turned off while it is
• The Program RUN LED fl ashes while a program is running. It is illuminated con-
tinuously when the program mode is activated.
• While a program is running, the program can only be stopped by pressing the
Program RUN button. All other buttons are inoperable when a program is run-
• The unit returns to the previous mode at the end of a program.
• The unit does not have to be running to set a program.
• During programming, the unit returns to the previous mode if no activity occurs
within approximately 35 seconds.
