Jumpers and Connectors 197
NOTE: If you assign a new system and/or setup password with the jumper
plug still in the "disabled" position, the system disables the new password(s)
the next time it boots.
6
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
7
Open the system. See "Opening the System" on page 87.
8
Move the password jumper back to the enabled position to restore the
password function. See Table 6-1.
9
Close the system. See "Closing the System" on page 89.
10
Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
11
Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "System
and Setup Password Features" on page 76.
book.book Page 197 Friday, November 20, 2009 2:56 PM
