A SERVICE OF

logo

Open as PDF
next previous
1. Follow the instructions in Preparing to Work Inside the Computer.
2. Remove the hinge cover (see Removing the Hinge Cover).
3. Remove the keyboard (see Removing the Keyboard).
4. Remove display assembly (see Removing the Display Assembly).
5. Use a plastic scribe to remove the six rubber bumpers from around the display assembly. It is not necessary to remove the oval bumpers located on the sides of
the display.
6. Remove the six M2.5 x 5-mm screws from around the display assembly.
7. Use your fingers to separate the bezel from the display assembly by lifting the inside edge of the bezel up and away from the center of the display assembly.
Replacing the Display Bezel
1. Follow the instructions in Preparing to Work Inside the Computer
2. Follow the instructions in Removing the Display Bezel.
3. Starting near the hinges (near the Dell logo), use your fingers to snap the new bezel into place.
4. Replace the six M2.5 x 5-mm screws to secure the bezel.
NOTICE: To avoid damaging the bezel, carefully separate the bezel from the display assembly by starting along the bottom of the display (near the Dell logo)
and working around the edge of the display towards the release latch.
1
display bezel
2
rubber bumpers (6)
3
M2.5 x 5-mm screws (6)
4
inside edge of bezel
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the
back panel) on the computer.