PAGE 6 OF 12
Child lock
Activating the child lock
• Switch all cooking zones off by pressing (A)
• The displays indicate ‘0’
• Press sensor (B). (Key lock symbol) The LED
above the Key lock symbol will switch on. The
child lock is now activated.
Switching child lock off
• Press touch pad sensor (A).
• Press touch pad sensor (B) The LED above the Key
lock symbol will switch off. Child lock is now off.
Remaining heat indicator
The remaining heat may be used for warming food as
long as the symbol ‘H’ remains on after the cooking zone
has been switched off.
Caution! Even when the symbol ‘H’ disappears the
hotplate may still be hot. Do not touch hotplates.
Switching a cooking zone off
• Press the (-) sensor (E) and set the power level to ‘0’, the hotplate will switch off after 3 seconds. Shortly
thereafter the hot surface indicator light on the hob will switch on, display (H) and remain on for 20 to
30 minutes after the plate is switched off. This is a reminder that the hob surface is still too hot to touch.
• Fast deactivation. Press both + and - (D and E) touchpad sensors simultaneously to switch the hotplate
off immediately.
Switching the hob off
• Switch the hob off by pressing the On / Off sensor (A).
Safety functions and error display
The hob is equipped with overheat safety sensors. When they are activated they turn off the hotplates nearest
to the control board.
Controls
Turning on the extended cooking zone
• Select the required power setting (from 1-9) by pressing “+” or “-” (D or E).
• Turn on the second zone by pressing sensor (C). The pilot light (C1) relating to the zone concerned
comes on; the second zone comes on together with the first.
Turning off the extended cooking zone
• The dual zone burner must be on
• Touch the dual zone sensor (C)
• The pilot light (C1) goes off and the second zone goes off
Safety cut out
Your hob is fitted with a temperature limiter preventing the hotplate from overheating should a pot boil dry .
If one or more hotplates is accidentally left on, a safety cut out turns them off after a certain amount of time
has elapsed. (See table below) The symbol “H” will display if the safety cut out has tripped. To prevent the
automatic cut out from tripping simply press the “+” or “-” sensor (D or E) before the limit time expires.
Level 1 2 3 4 5 6 7 8 9
Limit time (h) 10 5 5 4 3 2 2 2 1
