21
STEP 48: (SEE FIGURE 47)
• Placethelifthandleintotheliftbracketontherightside
of the snow thrower. Fasten the handle to the bracket
using two 5/16" x 1-3/4" hex bolts (D) and 5/16" Nylock
nuts (CC).
FIGURE 48 RIGHT SIDE VIEW
LIFT RELEASE
CABLE
HEX NUT
LOCK
WASHER
HEX NUT
CABLE
WIRE
LIFT
ROD
TRIGGER
ASSEMBLY
NOTE:Besuretheliftreleasecable'splasticcovering
stays inserted into the trigger assembly for the next step.
STEP 49: (SEE FIGURE 48)
• Pushthelifthandledownintothelockedposition.
Insert the end of the cable wire into the hole in the
liftrod.Placethethreadedttingintotheslotinthe
liftbracket,withonehexnutaboveandonehexnut
and the lock washer below the slot. Tighten the nuts,
adjusting them to eliminate slack in the cable wire.
ReferalsototheServiceandAdjustmentssectionon
page 29 in this manual.
HINT: For easier assembly of the lift release cable, tilt the
snow thrower forward onto the spiral auger.
FIGURE 47 RIGHT SIDE VIEW
5/16" NYLOCK NUT (CC)
5/16" x 1-3/4"
HEX BOLT (D)
ASSEMBLY OF THE SNOW THROWER
STEP 50: (SEE FIGURE 49)
• Tiltthesnowthrowerbackdowntotheground.
• Removethenylontiewhichfastenstheauger
drivebelttothedischargehousing,leavingthebelt
assembled around the pulleys.
• Removethenylontiewhichfastensthechutecrank
rod to the crank rod support tube.
• Assemblethecrankrodsupporttubetothebracket
on the left side of the discharge housing using two
5/16" x 1-1/4" carriage bolts (M), and 5/16" Nylock
nuts (CC).
FIGURE 50 LEFT SIDE VIEW
CHUTE CRANK ROD
CRANK SUPPORT TUBE
TILT CONTROL HANDLE
5/16" x 1-3/4"
CARRIAGE BOLT (L)
BOWED WASHER (Y)
5/16" NYLOCK NUT (CC)
TILT
CONTROL
ASSEMBLY
STEP 51: (SEE FIGURE 50)
• Attachthechutetiltcontrolassemblytothetopside
of the crank support tube using two 5/16" x 1-3/4"
carriage bolts (L), bowed washers (Y) and 5/16"
Nylock nuts (CC).
5/16" NYLOCK NUT (CC)
5/16" x 1-1/4"
CARRIAGE BOLT (M)
CRANK ROD
SUPPORT TUBE
DISCHARGE
HOUSING
FIGURE 49 LEFT SIDE VIEW