page 11
L1L1 L2L2
It is recommended that you test fan before
finalizing installation. Locate ON/OFF slider
switch on wall control and set to the ON
position. Test light and dimmer functions with
the L2 light button and then test fan speeds
with different fan speed control buttons on the
wall control. Next, locate remote control
transmitter. Test fan speeds with the different
fan speed buttons on remote control. Test the
light ON/OFF function with the L2 button on
the remote control. Test dimmer function by
holding down the L2 button for more than 2
seconds. If the remote control operates all of
the functions of the fan and light, battery has
been installed correctly. If the wall and/or
remote controls do (does) not operate all of
the fan/light functions, please refer to
"Troubleshooting" section to solve any issues.
Fan must be on LOW before setting the fan to
reverse direction. Use "reverse" button to
recirculate air depending on the season.
NOTE: If the remote control interferes with
other appliances, change code switches on the
transmitter (AND the wall control) to another
code. If you do change the code, turn power
off first, remove the battery cover, and, after
setting the new code, go back to the
instructions in the last paragraph of Section 10
(page 10).
12. Remote Control Operation.
13. Testing Your Fan.
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
button - used to REVERSE blade direction (fan must be set
on low before reversing blade direction)
button - turns fan OFF
L1 button - (for use with optional light kit, sold separately)
turns light ON/OFF when pressed once; dims light
when pressed and held down
L2 buton - turns upper light ON/OFF when pressed once; dims
upper light when pressed and held down
