page 9
10. Light Kit Assembly, 3 or 4-light Options.
Remove 3 screws from top of light kit fitter.
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic that
holds these 2 wires together.
Next, locate WHITE and BLACK wires in light kit
fitter labeled FOR LIGHT.
motor housing
switch
housing
molex
connections
Connect the WHITE wire from the light kit fitter to
the WHITE wire from the switch housing. Connect
the BLACK wire from the light kit fitter to the BLUE
(or BLACK) wire from the switch housing. Be sure
the molex connections snap together securely.
Align holes in light kit fitter with holes in switch
housing. [Note: The gap on the top edge of the
light kit fitter must align with reverse switch on the
switch housing for the proper fit.] Attach light kit
fitter with 3 screws that were previously removed.
Secure all 3 screws with Phillips screwdriver.
Loosen thumbscrews in light kit fitter. Attach glass
shades using thumbscrews. Do NOTovertighten
thumbscrews as glass may crack or break.
Install bulbs included with light kit.
Important: When replacing bulbs, please allow
bulbs and glass shades to cool down before
touching them.
Please proceed to Section 11 on the following page
to complete installation.
glass
shade
light kit
fitter
pull chain
extension
thumb-
screws
pull chain
extension
thumbscrew
switch
housing
reverse
switch
molex
connections
bulb
(or)
light kit
fitter
