INSTALLING THE SPINDLE
1. Remove the spindle from its package.
2. Follow the machine’s safety and installation instructions.
3. Clamp the spindle to the machine - using 4 screws (M5 - minimal length 15 mm).
Note: Locate the spindle on the position pins;
4. Remove plugs from air connections (2).
5. Connect inlet air pipe Ø6 mm to “AIR IN” (AI).
6. Connect outlet air pipe Ø6 mm to “AIR OUT” (AO) or you may use a silencer.
7. Remove black plastic nut from the end of the shaft.
8. Turn air supply on, spin the shaft by hand and make sure that the shaft is rotating freely.
9. Check for air pressure ( 5.5-6.5 [bar].)
10. Check for airflow ( 35-45 [lpm].)
11. Connect power cable to the driver.
12. Turn the driver on and spin the spindle. Start at low speed (1000 rpm for 5 minutes) and
slowly increase up to 5 Krpm.
13. Check for motor current at 5000 rpm, less 0.5 Amp.
8
