Figures 2 , 3 and 4 show recommended assembly
of bracket(s) and "C" wrap based on the
wall
installation of the sensors on each side of the
garage door as shown on page 19, or on the
garage door tracks
themselves.
For Garage Wall or Door Track
Installation
• Fasten the "C" wraps to the mounting brackets
having square holes, using the hardware shown
in Figure 2.
For Door Track
Installation Only
• Discard slotted bracket. Drill 3/8" holes in each
track and fasten securely with hardware as shown
in Figure 3.
For Wall
Installation
• Connect each assembly to a slotted bracket, using
the hardware shown in Figure 4. Note alignment
of brackets for left and right sides of the door.
• Finger tighten the lock nuts.
• Use bracket mounting holes as a template to locate
and drill (2) 3/16" diameter pilot holes on both sides
of the garage door, 4"-6" above the floor
but not
exceeding 6"
. (See warning on page 19.)
• Attach bracket assemblies with 1/4"x1-1/2"
lag screws as shown in Figure 4.
• Adjust right and left side bracket assemblies to the
same distance out from mounting surface. Make
sure all door hardware obstructions are cleared.
Tighten the nuts securely.
