9
Ma r r a k e s h
™
FAN PREPARATION
Step 17. Align the motor cover key hole slots with the three
screws in the motor adapter. Once the cover clears the screw
and washers, turn counter-clockwise to engage
Step 18. Securely tighten the screws by hand until snug.
KEY HOLE SLOT
Step 19. To hang the fan body in the canopy, hold the fan
body firmly and insert the nylon ball into the canopy opening.
Check that no wires were pinched. Rotate the fan body until
the slot in the nylon ball engages the canopy pin opposite
the canopy hatch opening.
CANOPY
PIN
SLOT
BALL
MOTOR WIRES
&
DOWNROD
GROUND
HOUSE WIRING
&
CROSSBAR
GROUND
CANOPY ELECTRICAL CONNECTIONS
Step 20. Connect the fan wires to the outlet
box wiring by placing the bare ends of the wires
together and then securing with a wire nut.
Connect in this order:
• GREENleadsfrommountingplateandfanto
GROUND conductor of power source. Secure
with wire nut.
• WHITEwirefromfantowhiteNEUTRALwire
in ceiling fixture outlet box.
Secure with wire nut.
• BLACKwirefromfantoblackPOWERwire
in ceiling fixture outlet box.
Secure with wire nut.
2 BLACK
WIRES
2 WHITE
WIRES
3 GREEN
WIRES
Inspect each wire nut and ensure that no bare
wire is visible; pull on each wire to test the
connection is mechanically sound.
HANGING THE FAN
CANOPY
Fan weighs 40 lbs.
