Installing an EPIM
SEHI100TX User’s Guide 4-9
4.6 INSTALLING AN EPIM
This section contains procedures on how to install the EPIM-100TX,
EPIM-100FX, or the EPIM-100FMB to upgrade or change the
capabilities of your SEHI. After installing a new EPIM, refer to the
appropriate EPIM section in Appendix A to verify proper operation.
Install an EPIM-100TX, EPIM-100FX, or an EPIM-100FMB as follows:
1. Remove the coverplate or the existing EPIM (whichever applies).
2. Slide the new EPIM into place, making sure that the connectors on the
rear of the EPIM align correctly and firmly with the connector inside
the SEHI. Refer to Figure 4-7.
3. Install the mounting screw.
Figure 4-7 Installing an EPIM
!
CAUTION
Observe all static precautions while handling an EPIM.
!
CAUTION
When removing an EPIM, pull the module straight out to
prevent damage to the connector.
LNK
EPIM-100TX
EPIM 1
1511_09
