A SERVICE OF

logo

Open as PDF
next previous
15
OTHER RECOMMENDATIONS FOR YOUR DISPENSER
• Whetherliquidconcentrateorgranulatedpowder,allproductmustbethoroughlymixedBEFOREaddingittothe
hoppers.
• Forbestresultswithgranita-typeproducts,useonlyproductswithanapparentbrixof12orhigher.Someproducts
may work with an apparent brix as low as 9. Your experimentation with other products will be the best guide in this
area. Using products with a brix lower than 12 may cause physical damage to the equipment drive system.
• Keepthepre-mixedliquidproductrefrigerated.Thisreducescooling/freezingtimeinthedispenser.
• Keepthehopperstopped-offduringpeakservingperiods.Addpre-mixedliquidproductasitisdispensed.Thisreduces
the cooling/freezing time and assures you of always having product ready to dispense.
• Keeptheproductlevelinthehoppershigherthantheauger.Iftheaugerisexposed,airwillbecomeentrappedinthe
mixture resulting in a clouded foamy consistency. This condition could also cause physical damage to the equipment
drive system.
• Youmaynditbenecialtoturndowntheicecontrolstokeeptheicegranulesfromgrowingtoolarge.Referto
Programming The Dispenser on page 10 for Setting the Consistency.
• Someproductsfreezeatalowertemperaturethanothers.Youmaynoticefrostoriceonthehoppers.Thisisnormal
and should not be a concern.
• Humidityintheairmaycausesweatingontheoutsidesurfacesofthehoppers.Thisistobeexpectedandshould
not be a concern. The drip trays beneath the hoppers will capture this and cause it to flow to the lower drip tray for
disposal.
• Somenoisesaretobeexpectedduringnormaloperationofthedispenser.Bybecomingfamiliarwiththenoisesmade
during normal operation, you will be better able to listen for problems.
• Anysignageattachedtotheequipmentmustnot be made with PVC, also known as Vinyl or Polyvinyl Chloride.
PREVENTIVE MAINTENANCE
Bunn-O-Matic
®
Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance
should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic
®
Corporation at
1-800-286-6070.
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.
NOTE: Equipment failure caused by product related issues are not covered by warranty.
Cycle
(months)
6
6
6
6
6
6
monthly
6 or as
needed
6 or as
needed
6
Item
Replace hopper drum seal.
Replace faucet seal.
Inspect auger shaft for abnormal wear.
Replace the auger shaft bushing
Replace the cooling drum seal.
Lubricate the motor shaft and motor shaft groove.
Clean condenser air filter.
Clean condenser coil.
Inspect and clean the condenser fan.
Inspect, clean, or replace the hopper tray drain tubes.
45246 052013