Check Out of Flame Failure Safety Device
1. To verif
operation of the flame failure safet
device, start the refri
erator in the
as mode
refer to li
htin
instructions on pa
e 6
and verif
the presence of a flame.
2. Turn off the
as at the manual shut-off valve or
at the main
as suppl
tank.
3. The flame will
o out and within 3 minutes the
flame safet
device will automaticall
close
an
audible click will be heard as this device closes
.
4. Turn the
as on at the manual shut-off valve.
5. Attempt to li
ht the burner b
placin
the mode
selection button to the
as mode.
Do not push in
the safety valve.
6. Without holdin
the safet
valve in, the burner
flame will not re-li
ht. This indicates the flame
failure safet
device is functionin
.
Description of Controls
(A) Safety Valve
The safet
valve is desi
ned so that an
loss of
flame will stop the
as flow to the burner. It is con-
trolled b
means of a thermocouple that is positioned
in the flame. As lon
as a flame is detected b
the
thermocouple, the valve will remain open. Upon
flame failure, the valve closes, shuttin
off the
as
flow to the burner. Durin
the
as i
nition process,
the safet
valve button must be held in until a flame
is established at the burner.
(B) Thermostat
The thermostat on the Norcold refri
erator controls
both the
as and AC electric operations,
thereby elimi-
nating the necessity of resetting each time a different
power source is selected
. Rotate the thermostat knob
clockwise to make the refri
erator cabinet colder.
(C) 120 Volts AC Operation
Pressin
button
C
selects the AC mode of operation.
When the AC mode is selected and AC volta
e is
supplied to the refri
erator, the refri
erator will operate
on 120 volts AC.
(D) 12 Volts DC Operation
Pressin
button
D
selects the DC mode of operation.
When DC is selected and DC is available to the refri
-
erator, the refri
erator will operate at full coolin
power.
The DC operation is a continuous run
no thermostat
control
mode.
(E) Gas Operation
Pressin
button
E
selects the Gas mode of opera-
tion. The refri
erator is e
uipped with electronic i
ni-
tion. When the
as mode is selected, the electronic
i
nition is ener
ized and sparkin
is
enerated at the
burner
Note: Push safet
valve button in and hold
until flame is present at burner
. Sparkin
will con-
tinue until a flame is present at the burner. When a
flame is sensed b
the electronic i
nition module, the
sparkin
ceases and the flame indicator
G
illumi-
nates indicatin
the refri
erator is operatin
on
as.
(F) Off
Pressin
button
F
will interrupt all power sources and
cease operation of the refri
erator.
A
B
C
D
E
F
G
Fi
ure 7
The refrigerator’s operating controls are located on top of the refrigerator. The control panel is
located on the top front surface directly above the refrigerator door.
5
