RackSwitch G8000 Application Guide
Chapter 8: Basic IP Routing
125BMD00041, November 2008
3. Determine which switch ports and IP interfaces belong to which VLANs.
The following table adds port and VLAN information:
NOTE – To perform this configuration, you must be connected to the switch Command Line
Interface (CLI) as the administrator.
4. Add the switch ports to their respective VLANs.
The VLANs shown in Table 8-3 are configured as follows:
Each time you add a port to a VLAN, you may get the following prompt:
Table 8-3 Subnet Routing Example: Optional VLAN Ports
Devices IP Interface Switch Ports VLAN #
Default router 1 49 1
Web servers 2 1 and 2 2
Database servers 3 3 and 4 3
Terminal Servers 4 5 and 6 4
RS G8000 (config)# vlan 1
RS G8000 (config-vlan)# enable
RS G8000 (config-vlan)# member 49 (Add ports to VLAN 1)
RS G8000 (config-vlan)# exit
RS G8000 (config)# vlan 2
RS G8000 (config-vlan)# enable
RS G8000 (config-vlan)# member 1,2 (Add ports to VLAN 2)
RS G8000 (config-vlan)# exit
RS G8000 (config)# vlan 3
RS G8000 (config-vlan)# enable
RS G8000 (config-vlan)# member 3,4 (Add ports to VLAN 3)
RS G8000 (config-vlan)# exit
RS G8000 (config)# vlan 4
RS G8000 (config-vlan)# enable
RS G8000 (config-vlan)# member 5,6 (Add ports to VLAN 4)
RS G8000 (config-vlan)# exit
Port 4 is an untagged port and its PVID is changed from 1 to 3.
