64
SERVSWITCH™ SUMMIT
Figure E-2. Frontward rackmounting of the USM.
To mount a USM or Base Unit facing rearward, as shown in Figures E-3 and E-4,
take these steps (matching the step numbers to the numbers in the figures):
1. Secure the cable-support bar to the front end of the side brackets, near the
side brackets’ “ears,” using two of the included screws.
2. Slide the USM or Base Unit between the side brackets, with its rear panel
facing the cable-support bar, until its front panel is flush with the back edges
of the side brackets.
3. Secure the USM or Base Unit to the side brackets using the remaining
included screws (three on each side).
4. Mount the entire assembly in your rack and secure the side brackets’ ears to
the rack’s front rails with your own screws, bolts, cage nuts, etc.
5. When you attach cables to the connectors on the rear panel of the USM or
Base Unit, drape them over the cable-support bar.
