3. Physical installation of the DMP-100 processor
3. PHYSICAL INSTALLATION OF THE DMP-100
PROCESSOR
Overview
• Installation requirements
• Connections of the DMP-100 processor
3.1 Installation requirements
Requirements
• The DMP-100 processor should no t be placed in a built-in installation or enclosure unless pr oper ventilation is provided.
• When using the unit in a multi unit rack assembly or closed assembly, the ambient temperature inside the assembly may not
exceed the rated ambient temperature (0 -50°C) of the processor. The installation should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
• When building in the DM P- 100 processor into a rack with cover door, be aware that a space of minimum 85 mm is needed
between the indicated reference and the cover door. This space is needed to guide the input cables to the inputs.
Image 3-1
The front side of the DMP-100 processor is considered as reference for this installation requirement.
• The DM P- 100 processor w ill require that air flow s freely in vent holes. Blocking these holes will greatly reduce the r eliability of
the unit and lead to the possibility of overheating.
• The DMP -100 processor should operate from an AC
power source. The DMP -100 processor is equipped with an auto-ranging
power supply from 100 to 240 volt (50–60 Hertz).
• When installed in a rack, the mounting should be such that no hazardous c ondition is achieved due to uneven mechanical
loading.
• When the mains switch located on the back of the DM P- 100 processor is not accessible due to rack mo unting, the soc ket outlet
supplying the rack shall be installed near the equipment and be easily accessible or a readily accessible disconnect devic e shall
be incorporated in the fixed wiring. When using a rack in an installation it is advisable to log the serial number of the device and
to activate the warranty figure by registering utilizing the included form.
• Do not place the DMP-100 processor on an unstable cart, s tand or table. The device may fall, causing personal injury and
serious damage to the processor.
• The data path between the DMP-100 processor and the LED display may not exceed ten (10) meter.
R59770263 DMP-100 15/09/2011
11
