Local Administrative Options
Static Addressing Installation
3-9
If you press the # button, the following text is displayed left-justified at the top of the display
while the system values are reset to defaults:
Once the system values are reset, the following prompt is displayed:
3. Press the * key to terminate the procedure without restarting the telephone.
Press the # key to restart the telephone.
The remainder of the procedure depends on the status of the boot and application files. Refer
to Appendix A.
Self-Test Procedure
3
To invoke 4600 Series IP Telephone self-test procedures, press the following sequence of keys on
the faceplate of the telephone:
Hold 8 3 7 8 # (Hold T E S T #)
The telephone illuminates each column of red and green LEDs associated with administrable
buttons sequentially for 0.5 second, from left to right across the telephone, in a repeating cycle.
The Speaker/Mute LED and the message waiting LED are illuminated along with the closest
column of LEDs. Buttons generate a button click if pressed, but do not generate any system-
specific signaling messages, DTMF, or invoke speakerphone or mute operation.
Telephones with displays display the following text, left-justified at the top of the display, for 1
second after self-test is invoked:
Self test
#=end
Then a block character (all pixels on) is displayed in all display character locations for 5 seconds.
Display of the block character is used to find bad display pixels.
One of the following is displayed:
4. To terminate the self-test, generate confirmation tone, and return the user interface to the
previous state, press the # button on the dial pad at any time.
Resetting
values.
Restart phone?
*=no #=yes
If self-test passes: Self test passed
#=end
If self-test fails: Self test failed
#=end
