A SERVICE OF

logo

5 Set the appropriate keywords in the software initialisation file. See Audio Keywords in the Visual Effects
and Finishing Configuration File on page 29
Wiring Audio Components
The following diagram illustrates how to connect the Discreet Native Audio hardware components to the
AJA breakout box.
AnalogInputs
AES/EBU DigitalOutputs
AnalogOutputs
3-4
1-2
1-25-67-8
3-45-67-8
12345678
12345678
AES/EBUDigitalInputs
RS-232
ADATIN1-8
ADATOUT1-8
WORDCLOCK
INPUT
OUTPUT
88192A/DD/ACONVERTER
IN IN
OUT OUT
IN IN
OUT OUT
VTR
AUDIO
GPI
IN OUT
IN
DIGITALAUDIO
OUT
1/2 3/4 7/85/6 1/2 3/4 5/6 7/8
WClk CVBS
RS.422D
LTC
RS422C
RS.422B
RS422A
RefLoop
RS-422
SDI1/A SDI2/B
In
Out
Ch.1(L) Ch.2(R)
Y/G/CVBS Pb/B/Y Pr/R/C
VideoMonitorOut
Ch.1/2 Ch.3/4
In
Out
Ch.5/6
In
Out
In
Out
Ch.1/2Out Ch.3/4Out Ch.5/6Out Ch.7/8OutCh.1/2In
Ch.3/4In
Ch.5/6In
Ch.7/8In
AES/EBU
Audio
Ch.7/8
AJA
AJA BOB (Front)
Lucid ADA 88192
Converter
to serial port 1 on
Linux workstation
Required for remote
control of converter
Digital
outputs
Input from
analog source
Output to
analog destination
Digital
outputs
Alternative setup
converted from
analog source
Configuring the Lucid ADA 88192 Converter
You must manually configure the Lucid converter for either remote or local control. This section describes
how to use the controls on the front of the converter to adjust settings, and lists the proper settings for
remote control and for local control.
26 | Chapter 5 Setting Up Audio Hardware