DiskMaster
Where solutions begin
ISO 9001:2000 Certified Company
1.8 Hardware Installation
Following is a quick installation guide to get you up and running. For further
details on each of the settings, please refer to manual on CD.
• Release two screws from the back side.
• Remove the aluminium plate.
• Release the 4 screws in the Hard Disk Mount.
• Place the first Hard Disk in to lower mont.
• Place the second Hard Disk in the upper area.
• Fasten all Hard Disk screws.
• For SATA Hard Disk: connect both power cable and data cable in
to Hard Disk. For Eide Hard Disk: connect pwer cable and IDE
cable in to Hard Disk, set jumper in Master mode and Slave mode
when install 2 HD.
• Slowly put the Hard Disk mount back to case.
• Fasten the 4 screws.
• Fasten the Aluminium plate screws.
• Please use the ethernet cable to connect the device and the
Router/Switch in the network.
• Please turn on the Power Switch.
Please check the following pictures.
