Save these instructions. For your safety, read and understand the information contained within. The owner and
operator shall have an understanding of this product and safe operating procedures before attempting to use this
product. Make certain that the operator thoroughly understands the inherent dangers associated with the use and
misuse of the product. If any doubt exists as to the safe and proper use of this product as outlined in this factory
authorized manual, remove from service immediately.
Inspect before each use. Do not use if leaking, broken, bent, cracked or otherwise damaged parts are noted. If the
cylinder has been or suspected to have been subjected to a shock load, (a load dropped suddenly, unexpectedly upon
it), discontinue use until checked out by an authorized factory service center. Owners and operators of this equipment
shall be aware that the use and subsequent repair of this equipment may require special training and knowledge. It is
recommended that an annual inspection be done by qualified personnel and that any missing or damaged parts,
decals, warning / safety labels or signs be replaced with factory authorized replacement parts only. Any cylinder that
appears to be damaged in any way, is worn or operates abnormally shall be removed from service immediately until
such time as repairs can be made.
PRODUCT DESCRIPTION
ATD Hydraulics Flat Body Cylinder is engineered to meet or exceed ANSI B30.1 Standards for Performance and Safety.
This cylinder is designed for rated capacity lifting, lowering, pushing, spreading and pressing jobs. ATD Flat Body
Cylinder Kit consists of a flat body cylinder, four magnetic adapters, owner's manual and a blow molded case.These
four pieces of different height adapters ranges from 0.25 inch to 1.25 inch are provided to extend the working height. A
wide variety of applications exist for this category of product. Special skill, knowledge and training may be required for
a specific task and the product may not be suitable for all the jobs described above. Unsuitable applications would
include applications that call for a device to move, level or support persons, animals, hazardous materials, mobile
homes / dwellings in general, mirrors and/or plate glass, and/or to connect/secure hatches, components, etc. between
bulkheads. The user ultimately must make the decision regarding suitability of the product for any given task and
therefore accept responsibility for that decision.
Note: Always check connections before using. Alteration of these products is strictly prohibited.
* Max. Working Pressure 10,000 PSI (700 Bar)
SPECIFICATIONS
Model
Number
Cylinder
Capacity
(tons)
Stroke
(in)
Cylinder Effec-
tive Area (in²)
Oil Capacity
(in³)
Collapsed
Height (in)
Extended
Height (in)
Weight
(lbs)
5
0.24
1.10
0.26
1.26 1.50
1.30Atd-5825
2
Magnetic adapter's height
Adapter I: 0.25 in
Adapter II: 0.50 in
Adapter III: 1.00 in
Adapter IV: 1.25 in
female
coupler
saddle
(ram)
magnetic
adapter
blow molded
case
TYPICAL INSTALLATION
hand pump
(not included)
