A SERVICE OF

logo

Open as PDF
next previous
VALVE CORE INSTALLATION
1. Insert the new valve core onto the tip of the shaft.
2. Tighten the shaft connection nut to the valve body.
3. Open the valve handle.
4. Push the shaft forward and turn the shaft clockwise to insert the valve core.
*NOTE: One can use the locking nut to help insert the valve core.
5. Once the valve core is in place, pull the shaft back and turn the valve knob to the closed position.
6. Remove the shaft from the valve body.
7. SLOWLY open the valve handle to assure the valve core is in place. If the valve is in place, the pressure in
the tool will dissipate quickly. If the valve core is not in place, quickly close the valve and try again.
8. Remove the adapter and valve body from the car.
81490-INST-ATD