46 Chapter 2
4 Carefully slide the drive carrier assembly backward until it is released from the floor of the
computer, then lift it out.
5 Configure your new hard disk drive.
Assign the Wide Ultra2 SCSI device a unique SCSI ID number.
Check the instructions that came with the device for information on selecting its setting.
Some manufacturers have World Wide Web sites that provide information on configuring
drives. You can also contact an Apple-authorized dealer, who may be able to install the drive
for a fee.
m If your server came with two Wide Ultra2 SCSI devices, set the SCSI ID to any number
but 0, 1, or 7.
A single factory-installed drive uses SCSI ID 0; a second factory-installed drive uses SCSI ID 1;
and a third factory-installed drive uses SCSI ID 2. The SCSI PCI card uses ID 7. If you select
one of these numbers for a new drive, the drive will not work properly.
Gently slide the entire drive carrier
assembly toward the rear of the computer
and lift it completely out. Be careful not
to crimp or abrade any wires that are
near or under the assembly.
