9-EN
Accessory List
• Head unit ..................................................................................1
• Power cable...............................................................................1
• USB extension cable.................................................................1
• Microphone ..............................................................................1
• Mounting sleeve.......................................................................1
• Carrying case ............................................................................1
• Bracket Key...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Owner’s Manual..................................................................1 set
Turning Power On and Off
Press r to turn on the unit.
Notes
• The unit can be turned on by pressing any other button except y.
• VSOURCE key blinks each time the unit is powered on.
Press and hold r for at least 2 seconds to turn off the
unit.
Note
• The first time power is turned on, the volume will start from level 12.
Source Selection
Press VSOURCE to change the source.
HD Radio SiriusXM
*1
Disc USB/iPod
*2
BLUETOOTH Audio
*3
PANDORA
*4
Auxiliary
*5
HD Radio
*1 Displayed only when a SiriusXM Tuner is connected.
*2 Displayed only when the iPod/iPhone is connected.
*3 Displayed only when Bluetooth IN is set to ON, refer to “Setting
the BLUETOOTH Connection (Bluetooth IN)” on page 30.
*4 Not displayed when Alpine APP is set to OFF, refer to “Setting
the communication mode with a Smartphone (Alpine APP)” on
page28.
*5 Displayed only when the AUX IN is set to ON, refer to “Setting
the AUX SETUP mode” on page 26.
Detaching and Attaching the Front Panel
1
Turn off the unit power.
2
Press y (OPEN) to open the front panel (figure 1).
To close the front panel, press the left side until it locks as shown
in the figure 2.
3
Grasp the front panel firmly, slide to the left , and then
pull to remove.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
• Do not leave the front panel open, or drive the car with the panel open
as it may result in an accident or malfunction.
1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Getting Started
MUTE
/
/ENTER
AUDIO/SETUP
SOURCE
Rotary encoder
Detaching
Attaching
figure 1 figure 2
