2. Installation
2.1. Starting the 8 Port Gigabit Web Managed Switch
This section provides a quick start guide for:
• Hardware and Cable Installation
• Management Station Installation
• Software booting and configuration
2.1.1. Hardware and Cable Installation
Please Note:
⇒ Wear a grounding strap to avoid damaging the switch with electrostatic discharge
⇒ Be sure that the power switch is in the ‘OFF’ position before you insert the power cord
•
Installing Optional SFP Mini-GBIC Modules
SFP
ort
Mini-GBIC module
Fig. 2.1: Installation of optional
SFP mini-GBIC
• Connecting the SFP Mini-GBIC Module to the Chassis:
The optional SFP Mini-GBIC modules are hot-swappable, so you can plug or unplug them
while the power is applied to the switch.
1. Verify that the mini-GBIC module is compatible with the SFP port on the switch
(for example, some switch manufacturers design their mini-GBIC modules to be
operable only in their branded devices).
2. Verify that the type of mini-GBIC you have selected for use will be compatible with the
type of fibre optic cable that is to be used.
3. Verify that the type of mini-GBIC you have selected for use will be compatible with the
fibre optic transceiver at the other end of the link (e.g. – compatible wavelength and
standard)
4. Slide the module along the slot and ensure that the module is properly seated against the
SFP slot socket/connector.
5. Install the media cable for network connection
6. Repeat the above steps, as needed, for each module to be installed into the switch
8
