137
Chapter 6: Replacing Assemblies
1690A,AD-series disassembly/assembly
To remove the deck
1 Using a Torx T-10 screwdriver, remove four screws that secure the deck to
the chassis.
2 Tilt the rear of the deck up and out of the chassis.
3 Lift the deck up and away from the chassis.
To remove the power supply
1 Do the following procedures:
To remove the chassis from the sleeve
To remove the front panel assembly
To remove the deck
2 Disconnect the power supply output cables, the on/off cable and the
power sense cable from the distribution board.
3 Disconnect the power supply line input cable from the power supply.
4 Using a Torx T-10 screwdriver, remove four screws that secure the power
supply to the bottom of the chassis.
