User’s Manual for Advantech SOM-A2552 series module V1.00
memory block. About detail
description, please reference
“SOM-
Interrupt Map”.
B48
nBUF_CS5 O
Static chip selects.
static memory devices such as ROM
programmable i
configuration registers. nBUF_CS5
can be used with variable latency I/O
devices.
Advantech default uses the pin as
display chip chip select pin.
nBUF_CS4 pin is used for SM501 on
SOM-A2552 & SOM-
no special application, Advante
strongly suggest user to open this
pin in CSB.
Pull high
with
100Kohm
A48
DMA_REQ1 I
Channel 1 DMA Request.
the DMA Controller that an external
device requires a DMA transaction. If
user wants to design a controller in
CSB with DMA mode, pleas
with ae.risc@advantech.com.tw
If use doesn’t want to use this pin as
DMA_REQ, use could use the pin as
GPIO. The pin connects to SoC
PXA255 GPIO19.
Pull low
with 1Kohm
B49
MBREQ I
Memory Con
master request.
device to request the system bus
from the Memory Controller. If user
wants to design a controller in CSB
with this pin function, please check
with ae.risc@advantech.com.tw first.
If use doesn’t want to use this pin as
DMA_REQ, use could use the pin as
GPIO. The pin connects to SoC
PXA255 GPIO14.
Pull low
with 1Kohm
A49
DMA_ACK1 O
Channel 1 DMA acknowledge.
Notifies an external device that it has
been a
controller. If user wants to design a
controller in CSB with DMA mode,
ae.risc@advantech.com.tw first.
If use doesn’t want to use this pin as
DMA_ACK, use could use the
GPIO. The pin connects to SoC
PXA255 GPIO22.
No pulling
