5-4 ADAM-5000
Software Utilities
current values of its inputs. An example is shown in Figure 5-2 for an
ADAM-5000 system.
Figure 5-2 Setup options
There are three different options: System Setting, Module Setting and
Output Data.
Highlight the parameter you wish to change and press <Enter>. A
window will appear with the configuration options for that parameter.
Highlight the proper value and hit <Enter>. For some parameters, you
will need to type in a specific value after selecting the parameter.
System Setting
The Checksum and Baud rate options need special attention since
they can only be changed when an ADAM-5000 is in the INIT* state.
To place a system in INIT* state, its INIT terminal should be connect-
ed to its GND terminal. If the ADAM-5000 is not in INIT* mode, an
error message will appear. When it is in INIT* mode, a window to
change the Checksum or an option window showing you the valid
baud rates will appear, depending on your choice.
