Installing and Operating the Module 3 - 17
6. Attach the other ends of the cables to any of the following:
❑ A 10BASE-T transceiver
❑ A patch panel
❑ A 10BASE-T adapter card
Configuration in a Managed Environment
With an EMM already installed, all DIP switch settings on the 24-Port
Module are ignored. For this reason, 3Com recommends that you use
network management commands instead of DIP switches to configure the
module.
Note: Do not use a slave management module to manage (for
example, configure or get statistics for) a 24-Port Module.
Note: To fully support Model Number 5124M-TPCL, you must have
EMM Version v3.2 or later. To fully support Model Number
5124M-TP, you must have EMM Version v4.30 or later.
The following sections describe important module configuration issues and
settings you can configure for both models of the 24-Port Module:
❑ If Management is Not Available
❑ Before Configuring the Module
❑ Enabling Ports
❑ Enabling Port Redundancy
❑ Enabling Link Integrity
❑ Selecting a Network
