Installing the Network Jack
15
Installing the Adapter Plate and Pass-Through Ports
If you want to install the blank adapter plate, or if you want to
use pass-through ports for connecting an analog or PBX digital
telephone or for setting up a connection to a separate network
segment, purchase supported connectors and install them on
the appropriate Network Jack adapter plate (included with the
single pack; available for purchase separately with the 20-pack).
For a list of connectors that are supported with the Network Jack
adapter plates, go to www.3com.com.
1
Pull the network cable(s) from the wiring closet to the
location of the Network Jack.
NOTE:
If you are not planning on installing the adapter
plate and pass-through ports, skip this section. Go to
“Planning the Installation” on page 17 to begin the
installation.
