5-12
C
H
A
P
T
E
R
5:
A
D
D
I
T
I
O
N
A
L
M
A
N
A
G
E
M
E
N
T
U
S
I
N
G
VT100
Status
Enabled
/ Disabled
This field shows whether the data link protocol is
enabled. Choose Disabled if you wish to prevent
access for any reason, such as security considerations.
Data Link Protocol
This field shows the name of the
IPX data link layer protocol.
OK
Press [Return] when the
OK
button is highlighted
to action your selections for this screen. You are
returned to the Main Menu.
If you have changed the parameters, you need to
reset the hub to effect the changes.
SETUP TRAPS
Press [Return] when the
SETUP TRAPS
button is highlighted to set up the parameters for
traps.
CONSOLE PORT
Press [Return] when the
CONSOLE
PORT
button is highlighted to set up the console port
parameters.
CANCEL
Press [Return] when the
CANCEL
button is
highlighted to abandon this screen without
actioning any changes, and return to the Main Menu.
Setting Up Traps
The Trap Setup screen, as shown in
Figure 5-6
, is
used to set up
traps
. Traps are messages sent across
the network to an IP/IPX-based network
management application which inform the network
manager of the status of your hub.
Figure 5-6
Trap Setup Screen
Your Transcend IP/IPX-based network manager may
automatically set up the trap destination addresses
for you. Check the accompanying documentation.
16710.bk : MANVT100.FRM Page 12 Tuesday, October 7, 1997 11:38 AM
