Filter
Top Products
6-22
PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAUT0007
Replacing the fuse
The fuse holder is located beside the
battery. Remove panel A to access
the fuse. (See page 6-5 for panel re-
moval and installation procedures.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn
off all electrical circuits.
2. Remove the blown fuse, and
then install a new fuse of the
specified amperage.
Specified fuse: 7 A
EC000103
cC
Do not use a fuse of a higher am-
perage rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to “ON” and turn
on the electrical circuits to
check if the devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
1. Fuse
1
EAU01008
Troubleshooting
Although Yamaha scooters receive
a thorough inspection before ship-
ment from the factory, trouble may
occur during operation. Any prob-
lem in the fuel, compression, or ig-
nition systems, for example, can
cause poor starting and loss of
power.
The following troubleshooting chart
represents a quick and easy proce-
dure for checking these vital systems
yourself. However, should your
scooter require any repair, take it to
a Yamaha dealer, whose skilled tech-
nicians have the necessary tools,
experience, and know-how to ser-
vice the scooter properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are of-
ten inferior, have a shorter service
life and can lead to expensive repair
bills.
5PJ-F8199-13.pm65 5/25/2004, 5:31 PM58