Filter
Top Products
6
SET-UP INSTRUCTIONS
Bulb & Diffuser installation
1. Insert bulb into lamp by fi rmly holding bulb base and push into the
socket (See below)
Note: Make sure bulb is fully inserted into the socket. The bottom of
the bulb base should touch the plastic housing of the lamp.
2. Attach the plastic diffuser to the lamp body by fi rst inserting the tab
located at the bottom of the diffuser (A) into the opening of the lamp
base (B).
3. Rotate the plastic diffuser and align the side snap tabs (C) into
position – press fi rmly to snap parts together.
4. Plug lamp into a standard 110-120V outlet, switch it on and begin
enjoying the benefi ts of Verilux
®
Natural Spectrum
®
light!
Note: please allow a few minutes for the bulb to warm up to full
illumination.
Note: if bulb does not illuminate instantly, please refer to the
troubleshooting section of this manual.
A
B
C