Filter
Top Products
11. PROGRAMMING PROCEDURES
11.15 LON SYSTEM
11-25
Data Transmission
The following data is down-line-loaded.
Page 1: (0). All (PLU+ING+NUTRI) Page 2: (0). SPEED KEY
(1). PLU (1). LOGO
(2). ING. (2). VENDOR
(3). NUTRITION (3). FREE FORMAT
(4). U. PRICE (4). ADDRESS (SL-9000N only)
(5). DATE/TIME (5). INITIAL (#0 - #19, SL-9000N only)
(6). MESSAGE LINK (Message) (9). CHANGE PAGE
(7). LOCK SCALE (Check the LON cable)
(8). OPEN SCALE (Release the lock after checking the LON cable.)
(9). CHANGE PAGE
Enter a DLL data.
Release the scale from the error.
0: CANCEL
1: RETRY
2: CONTINUE
ENTER
n
p
NOTE: DLL is performed automatically in the following two ways. It is selectable by the
Initial Settings #0-6 and #0-7.
(1) LOCK SCALE method
Step 1: “LOCK SCALE” is sent. (*1)
Step 2: Selected data is sent. (*2)
Step 3: “OPEN SCALE” is sent.
*1: If an error occurs during step 1, the error terminal ID# is indicated.
Select “cancel”, “retry” or “continue” to release the terminal from an
error.
cancel: Quits the operation after sending “OPEN SCALE”
retry: Tries to send “LOCK SCALE” again.
continue: Ignores the error terminal and starts DLL.
*2: If an error occurs during step 2, the error terminal ID# is indicated.
Press the key to return to the DLL data selection menu.
(2) Background DLL
Step 1: Selected data is sent. (*3)
*3: If an error occurs, the error terminal ID# is indicated. Press the
key to return to the DLL data selection menu.
CLEAR
CLEAR