Filter
Top Products
1. INTRODUCTION
EMl-31061A
1. INTRODUCTION
Dixonnecl the plug.
n
When moving the machines, be
sure to first unplug the power cords.
Moving the machines with the power
cords plugged in may damage the
cords and cause fire or electric
Diiconnect the plug.
H When unplugging the power cords,
be sure to hold and pull on the plug
portion. Pulling on the cord portion
may cut or expose the internal wires
and cause fire or electric shock.
H Do not lean against the machine. It
may fall and be damaged.
n
When opening the cash drawer, be
careful not to let the drawer hit
children’s heads, etc., as this may
w Be sure to move large scale
machines with two or more people. In
addition, machines should be mobed
after first confirming that connecting
wires between machines and
externally connected wires, etc. have
been removed. Failure to observe
these precautions may result in injury.
Precaution
The following precautions will help to ensure that this machine will continue to function correctly.
@ Try to avoid locations that have the following adverse conditions:
l
Temperatures below 0°C and above 40°C
l
Direct sunlight
l
Shared power socket
l
Excessive vibration
@
@
Do not subject the weighing platter to sudden shocks.
@
Do not press the keys too hard. Keys will operate correctly if they are touched lightly.
Clean the cover and weighing platter by wiping with a dry cloth or a cloth soaked with detergent
0
and wrung out thoroughly. Never use thinner or other volatile solvent for cleaning.
To ensure that the scale is operating correctly, place a known weight on the platter and check it
for correct weight measurement. This should be done every morning before starting normal
operations.
6
8
At the end of the day, turn the power OFF, then clean and inspect the exterior of the scale.
Try to avoid using this equipment on the same power supply as high voltage equipment or
equipment likely to cause mains interference (freezer cabinets etc.).
@ USE ONLY TEC SPECIFIED media.
@ DO NOT STORE the media where they might be exposed to direct sunlight, high temperatures,
high humidity, dust, or gas.
@ When moving the scale, take hold of the case and lift the scale. Never hold the remote unit.
1-4