Tanita HD-372F Scale User Manual


 
Features
Digital accuracy and reliability.
Elegant, contemporary styling.
Durable construction, non-skid surface.
“L” message appears when the lithium battery needs replacing.
Back light display using 9 volt battery
Before Use
Pull-off the protective tab from
the battery.
Select your preferred weight mode using the
Weight Mode Switch.
Placing Scale
The scale should be used on a hard even surface for accurate weighing. Not
recommended for use on carpeted surfaces. Placing scale on a very soft, deep
pile rug may affect weighing accuracy.
Instructions for Use
Gently tap the center of the scale with your
foot. When “00.0” shows on the display, step
on the scale (Fig. 1).
Stand still while the LCD flashes “00.0” for
3 seconds. The LCD will display your weight
(Fig. 2). If you step off from the scale, your
weight will be displayed for 5 seconds then
the scale will automatically shut off. If you
remain on the scale, the weight will be displayed for 10 seconds then
automatically shut off.
Note: If you step on the scale without tapping the platform, the display will
show “Err” for 2 seconds then automatically shut off.
Once the scale displays “00.0”, if you do not step on the scale in
10 seconds, the scale will automatically shut off.
“Err” will appear on the display when the scale’s weight capacity is
exceeded.
Care and Maintenance
Place the scale in an area free from heating equipment, high humidity,
or extreme temperature changes.
Never submerge the scale in water or spill chemical liquids on it. To clean,
use a dampened cloth and mild detergent.
Avoid excessive impact or vibration to the unit.
FIG. 2FIG. 1
TAP HERE
1
2
HD-372_D 2005.4.21 10:52 AM Page 3